To enable communication between your system and iDRAC, you must first configure the network settings based on your network infrastructure. The network settings option is set to
DHCP, by default.
NOTE:For static IP configuration, you must request for the settings at the time of purchase.
You can set up the iDRAC IP address using one of the interfaces in the table below. For information about setting up iDRAC IP address, see the documentation links provided in the table below.
Table 1. Interfaces to set up iDRAC IP addressThis table lists the interfaces to set up the iDRAC IP address.
Interface
Documentation links
iDRAC Settings utility
Integrated Dell Remote Access Controller User's Guide at
iDRAC Manuals or for system specific Integrated Dell Remote Access Controller User's Guide, go to
PowerEdge Manuals >
Product Support
page of your system >
Documentation.
NOTE:To determine the most recent iDRAC release for your platform and for latest documentation version, see KB article
KB78115.
OpenManage Deployment Toolkit
Dell OpenManage Deployment Toolkit User's Guide available at
OpenManage Manuals > OpenManage Deployment Toolkit.
iDRAC Direct
Integrated Dell Remote Access Controller User's Guide at
iDRAC Manuals or for system specific Integrated Dell Remote Access Controller User's Guide, go to
PowerEdge Manuals >
Product Support page of your system >
Documentation.
NOTE:To determine the most recent iDRAC release for your platform and for latest documentation version, see KB article
KB78115 .
Lifecycle Controller
Dell Lifecycle Controller User's Guide at
iDRAC Manuals or for system specific Dell Lifecycle Controller User's Guide, go to
PowerEdge Manuals >
Product Support page of your system >
Documentation.
NOTE:To determine the most recent iDRAC release for your platform and for latest documentation version, see KB article
KB78115.
NOTE:To access iDRAC, ensure that you connect the ethernet cable to the iDRAC dedicated network port or use the iDRAC Direct port by using the micro USB (type AB) cable.
You can also access iDRAC through the shared mode, if the system is set it to share iDRAC port with OS as an OS NIC or shared LOM mode enabled.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\