Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge XR8620t Installation and Service Manual

PDF

Installing the NVMe module on the ROR N1 module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the latch on the snap clip and rotate the latch to a vertical position.

Steps

  1. Align the NVMe module at an angle with the ROR N1 module connector.
  2. Insert the NVMe module firmly until it is fully seated in the ROR N1 module connector.
  3. To secure the NVMe module on the ROR N1 module, insert the engage pin to rotate the latch to a vertical position and then insert the latch into the snap clip.
    Figure 1. Installing the ROR N1 NVMe module

    This image shows installing the ROR N1 NVMe module

Next steps

  1. Installing the ROR N1 module.
  2. Follow the procedure listed in the After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\