Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge XR8620t Installation and Service Manual

PDF

Installing the M.2 SSD module on the BOSS-N1 card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align the M.2 NVMe module at an angle with the M.2 direct riser connector on BOSS-N1 card.
  2. Insert the M.2 NVMe module firmly until it is fully seated in the M.2 direct riser connector.
  3. Replace the screw and tighten it to secure the M.2 SSD module on the BOSS-N1 card.
    NOTE:The BOSS-N1 card can accommodate two M.2 SSD modules, repeat the same procedure to install the second M.2 SSD module.
    Figure 1. Installing the M.2 SSD module

    This image shows installing the M.2 SSD module on BOSS-N1 card.

Next steps

  1. Installing the BOSS-N1 card.
  2. Follow the procedure listed in the After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\