- Notes, cautions, and warnings
- About this document
- Dell PowerEdge XR8620t system configurations and features
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Minimum configuration to POST
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- XR8000r chassis
- Sled cover
- Air shroud
- M.2 direct riser module
- ROR N1 module
- 2U sled
- Storage interposer module
- Cooling fans
- Expansion cards and expansion card risers
- BOSS-N1 card
- Power distribution board
- Cable routing
- System memory
- Processor and heat sink module
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- Using system diagnostics
- Getting help
- Documentation resources
Dell PowerEdge XR8620t Installation and Service Manual
Installing a cooling fan on 2U sled
Prerequisites
- Follow the safety guidelines listed in Safety Instructions.
- Follow the procedure listed in Before working inside your system.
- Remove the air shroud.
NOTE:Observe the fan cable routing or make a note of the fan cable routing.
Steps
- Lower the fan module into the cage until it is seated firmly.
NOTE:The airflow directional arrow outward on the fan indicates Reverse-Air-Flow (RAF).
Figure 1. Installing a cooling fan 
- Route the fan cables properly through the fan guard and connect the cable to the connector on the power distribution board (PDB) of the 2U sled as shown in the image below.
NOTE:Fan 5, 6, 7 and 8 are connected to the 2U PDB.
Figure 2. 2U sled fan cable routing 
Next steps
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\