- Notes, cautions, and warnings
- About this document
- Dell PowerEdge XR8620t system configurations and features
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Minimum configuration to POST
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- XR8000r chassis
- Sled cover
- Air shroud
- M.2 direct riser module
- ROR N1 module
- 2U sled
- Storage interposer module
- Cooling fans
- Expansion cards and expansion card risers
- BOSS-N1 card
- Power distribution board
- Cable routing
- System memory
- Processor and heat sink module
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- Using system diagnostics
- Getting help
- Documentation resources
Dell PowerEdge XR8620t Installation and Service Manual
Minimum configuration to POST
The components listed below are the minimum configuration to POST:
- One processor (CPU) in processor socket
- Two memory module (DIMM) in socket A1 and A2
- One power supply unit
- XR8000r chassis (Power Distribution Board, cables)
- System board
- XR8620t sled
NOTE:The system may generate errors when it is in a minimum to POST configuration. This behavior is expected as the configuration is not validated for operational use, instead, only for troubleshooting or diagnostic purposes.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\