- Notes, cautions, and warnings
- About this document
- Dell PowerEdge XR8620t system configurations and features
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Minimum configuration to POST
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- XR8000r chassis
- Sled cover
- Air shroud
- M.2 direct riser module
- ROR N1 module
- 2U sled
- Storage interposer module
- Cooling fans
- Expansion cards and expansion card risers
- BOSS-N1 card
- Power distribution board
- Cable routing
- System memory
- Processor and heat sink module
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- Using system diagnostics
- Getting help
- Documentation resources
Dell PowerEdge XR8620t Installation and Service Manual
Installing the side cover
Prerequisites
- Follow the safety guidelines listed in Safety Instructions.
- Follow the procedure listed in Before working inside your system.
- Install the 2U top sled on the 2U node.
Steps
- Align the side cover with the slot on the 2U sled.
- Using a Phillips 2 screwdriver, tighten the captive screws to secure the 2U side cover.
Figure 1. Installing the 2U sled side cover 
Next steps
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\