Precision 7960 Rack Service Manual

The following images indicate the location of the LOM card and provide a visual representation of the installation procedure.

1. Install the system board.
2. Install the processors and heat-sink module.
3. Install the riser card 4.
4. Install the riser card 2.
5. Install the riser card 3.
6. Install the riser card 1.
7. Install the memory module.
8. Install the right wall bracket.
9. Install the left wall bracket.
10. Install the right control panel.
11. Install the left control panel.
12. Install the cooling fan assembly.
13. Install the air shroud.
14. Install the system cover.
15. Follow the procedure in After working inside your computer.
    NOTE:Your computer’s Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program after you replace the system board.
    NOTE:Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup program. You must make the appropriate changes again after you replace the system board.