Dell PowerEdge T360 Installation and Service Manual

Removing the control panel assembly

1. Using a Phillips 2 screwdriver, remove the screws that secure the system side cover to the chassis.
2. Tilt and slide the system side cover towards the rear of the system and remove the system side cover.

   

3. Pull out the tabs on both sides of the front faceplate and remove the front faceplate out of the system.
   NOTE: For easy removal of tabs on the left side of the faceplate, it is recommended to use screwdriver or plastic scribe.

   

4. To remove control panel cage:
   1. Press the side lever and slide out the control module cage from the system.
   2. Disconnect the cable from the control panel assembly.

      

5. To remove control panel assembly:
   1. Using a Phillips 2 screwdriver, remove the screws that secure the control panel assembly to the cage.
   2. Slide out and remove the control panel assembly from the cage.