Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T360 Installation and Service Manual

PDF

Removing the GPU

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If required, remove the air shroud.

Steps

  1. Loosen the captive screw and tilt the metal bracket that holds the expansion cards.
  2. Hold the GPU by the edges, and pull the card up to remove it from the expansion card connector on the system board.
    Figure 1. Removing the GPU
    This image shows how to remove the GPU.
  3. If the GPU is not going to be replaced, install metal filler.
  4. Tilt the metal bracket and tighten the captive screw.
    Figure 2. Installing the metal filler
    This image shows how to remove the filler bracket.
    NOTE:Filler brackets must be installed in empty GPU slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.

Next steps

Replace the GPU.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\