Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T360 Installation and Service Manual

PDF

Installing the BOSS-N1 module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the air shroud.
  4. If installed, remove the front bezel.

Steps

  1. Using a Phillips 2 screwdriver, remove the screw that secures the BOSS-N1 module blank from the system.
  2. Slide out the BOSS-N1 module blank from the system using a flat head screwdriver.
    Figure 1. Removing the BOSS-N1 module blank
    This image shows the removal of the BOSS-N1 module blank.
  3. Align the BOSS-N1 module to the BOSS-N1 slot on the chassis and push it into the slot.
  4. Using a Phillips 2 screwdriver, secure the BOSS-N1 module to the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 2. Installing the BOSS-N1 module
    This image shows the installation of the BOSS-N1 module.
  5. Connect the cables to the system board connectors.
    NOTE:Route the cables properly to prevent them from being pinched or crimped.

Next steps

  1. If removed, install the front bezel.
  2. Install the air shroud.
  3. Follow the procedure that is listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\