Hold the system board by its edges, and align it towards the back
of the system.
Lower the system board into the system chassis until the connectors at
the back of the system board align with the slots on the chassis,
and the screw holes on the system board align with the standoffs on
the system chassis [1,2].
Replace
the and the screws (5) that secure the system
board to the system [1,2].
Route all the cables through the routing clips [1].
Align the cables with the pins on connectors on the system board
and connect the following cables to the system board:
Power switch [2]
Power cable [3]
CPU power [4]
Intrusion switch [5]
Connect the
power cable, optical drive data cable and hard drive data cable [1, 2, 3].
Insert the hook on the I/O panel into the slot on the chassis and rotate to close the I/O panel [4].
Replace the screw to secure the I/O panel to the chassis [5].