- Notes, cautions, and warnings
- Views of OptiPlex All-in-One Plus 7410
- Set up your computer
- Specifications of OptiPlex All-in-One Plus 7410
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex All-in-One Plus 7410 Owner's Manual
Removing the stand
Prerequisites
- Follow the procedure in Before working inside your computer.
About this task
NOTE:Depending on the stand installed on your computer, refer to the corresponding image shown in the procedure.
The following image(s) indicate the location of the stand and provides a visual representation of the removal procedure.
Steps
- Place the display-assembly base on a clean and flat surface.
- Press and hold down on the tab that secures the stand to the display-assembly base.
- Slide and lift the stand off the display-assembly base.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\