- Notes, cautions, and warnings
- Views of OptiPlex All-in-One Plus 7410
- Set up your computer
- Specifications of OptiPlex All-in-One Plus 7410
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex All-in-One Plus 7410 Owner's Manual
Removing the memory
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the stand.
- Remove the back cover.
About this task
The following image(s) indicate the location of the memory and provides a visual representation of the removal procedure.
Steps
- Using the tab on the DIMM door, pry open and lift the DIMM door on the system-board shield to access the memory slots.
- Using your fingertips, carefully spread apart the securing clips on each end of the memory-module slot until the memory module pops out.
- Remove the memory module from the memory-module slot.NOTE:Repeat steps 2 to 3 for each memory module installed on your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\