- Notes, cautions, and warnings
- Views of OptiPlex All-in-One Plus 7410
- Set up your computer
- Specifications of OptiPlex All-in-One Plus 7410
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex All-in-One Plus 7410 Owner's Manual
Installing the retractable-camera assembly
Prerequisites
About this task
The following image(s) indicate the location of the retractable-camera assembly and provides a visual representation of the installation procedure.
Steps
- Slide the retractable-camera assembly under the heat sink into its slot on the display-assembly base.
- Align the screw holes on the retractable-camera assembly with the screw holes on the display-assembly base.
- Replace the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
- Connect the camera cable (WEBCAM) to the system board.
- Place the camera-assembly bracket over retractable-camera assembly.
- Align the screw holes on the camera-assembly bracket with the screw holes on the display-assembly base.
- Replace the two screws (M3x5) that secure the camera-assembly bracket to the display-assembly base.
Next steps
- Install the system-board shield.
- Install the back cover.
- Install the stand.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\