- Notes, cautions, and warnings
- Views of OptiPlex All-in-One Plus 7410
- Set up your computer
- Specifications of OptiPlex All-in-One Plus 7410
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex All-in-One Plus 7410 Owner's Manual
Installing the power-supply fan
Prerequisites
About this task
The following image(s) indicate the location of the power-supply fan and provides a visual representation of the installation procedure.
Steps
- Place the power-supply fan on the display-assembly base.
- Align the screw holes on the power-supply fan with the screw holes on the display-assembly base.
- Replace the two screws (M3x5) that secure the power-supply fan to the display-assembly base.
- Route the antenna cables through the routing guides on the display-assembly base and the power-supply fan.
- Route the audio-board cable through the routing guides on the display-assembly base and the power-supply fan.
- Thread the power-supply fan cable under the I/O bracket and route the power-supply fan cable through the routing guide on the display-assembly base.
- Connect the power-supply fan cable (FAN SYS) to the system board.
Next steps
- Install the bottom cover. .
- Install the power-supply unit.
- Install the I/O cover.
- Install the system-board shield.
- Install the back cover.
- Install the stand.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\