Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex All-in-One Plus 7410 Owner's Manual

PDF

Installing the I/O bracket

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the I/O bracket and provides a visual representation of the installation procedure.

Installing the I/O bracket

Steps

  1. Place and align the I/O bracket with the display-assembly base.
  2. Align the I/O slots to the I/O ports and the screw holes on the I/O bracket with the screw holes on the display-assembly base.
  3. Replace the two screws (M3x5) that secure the I/O cover to the display-assembly base.
  4. Place the power-supply connector cable bracket on the display-assembly base.
  5. Align the power-supply cable connector bracket screw holes with the screw holes on the display-assembly base.
  6. Replace the two screws (M3x5) that secure the power-supply cable connector bracket to the display-assembly base.

Next steps

  1. Install the bottom cover.
  2. Install the I/O cover.
  3. Install the system-board shield.
  4. Install the back cover.
  5. Install the stand.
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\