Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex All-in-One Plus 7410 Owner's Manual

PDF

Installing the audio board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the audio board and provides a visual representation of the installation procedure.

Installing the audio board

Steps

  1. Place the audio board on the display-assembly base.
  2. Align the screw holes on the audio board with the screw holes on the display-assembly base.
  3. Replace the two screws (M3x5) that secure the audio board to the display-assembly base.
  4. Connect the power cable (DB-PWR) to the audio board and close the latch.
  5. Connect the high-speed cable (DB-PWR) to the audio board and close the latch.
  6. Place the audio-board shield on the display-assembly base.
  7. Align the screw holes on the audio-board shield with the screw holes on the display-assembly base.
  8. Replace the three screws (M3x5) that secure the audio-board shield to the display-assembly base.

Next steps

  1. Install the I/O bracket.
  2. Install the bottom cover.
  3. Install the I/O cover.
  4. Install the system-board shield.
  5. Install the back cover.
  6. Install the stand.
  7. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\