Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell OptiPlex 7070 Ultra Service Manual

PDF

Removing the hard-drive assembly

Prerequisites

  1. Follow the procedure in Before working inside your device.

About this task

The figure indicates the location of the hard-drive assembly module and provides a visual representation of the removal procedure.

Removing the hard drive

Steps

  1. Remove the M2x3 screw that secures the hard-drive assembly to the cover.
  2. Turn the hard-drive assembly.
  3. Lift the cable release latch and disconnect the hard-drive cable from the connector on the system board.
  4. Carefully unroute the hard-drive cable from the slot on the chassis.
    NOTE:Observe the routing of the hard-drive cable inside the chassis as you remove them. Route the cable properly when you replace the component to prevent the cable from from being pinched or crimped.
  5. Remove the hard-drive assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\