After working inside your device
About this task
After you complete any replacement procedure, ensure that you connect any external devices, cards, and cables before turning on your computer.
Steps
-
Install the device in the stand:
Installing the device on Fixed-height stand or Height-adjustable stand:
-
Unlock the latch on the lower chassis of the stand to remove the stand cover.
-
Align and position the top side of the device to the upper chassis of the stand back cover.
-
Align the power button on the device with the slot on the stand back cover chassis.
-
Press the device until the retention latch clicks into place and secures it.
-
Connect the keyboard/mouse, network, power adapter, and USB Type-C cable to the device.
CAUTION:To connect a network cable, first plug the cable into the network device and then plug it into the device.
-
Slide the back cover, along with the device, into the stand until it clicks into place.
-
Lock the stand cover.
Installing the device on offset VESA mount:
-
Align the screw holes on the device to the screw holes on the offset VESA mount.
-
Install the four screws to secure the device to the offset VESA mount.
-
Align the screw holes in the offset VESA mount with the screw holes on the back cover of the monitor.
-
Install the four screws to secure the offset VESA mount to the monitor.
-
Align the tabs on the adapter that is attached to the stand, with the slots on the back of the monitor.
-
Slide the tabs on the stand adapter into its slots on the monitor.
-
Connect the keyboard/mouse, network, power adapter, and USB Type-C cable to the device.
CAUTION:To connect a network cable, first plug the cable into the network device and then plug it into the device.
-
Turn on your device.
-
If required, verify that the device works correctly by running
ePSA diagnostics.