Dell OptiPlex 7070 Ultra Service Manual

Installing the hard-drive assembly

If you are replacing a component, remove the existing component before performing the installation procedure.

The figure indicates the location of the hard-drive assembly module and provides a visual representation of the installation procedure.

Installing the hard drive

Place the hard-drive assembly on the cover.
Route the hard-drive cable through the slot on the chassis.
Connect the hard-drive cable to the connector on the system board.
Route the hard-drive cable to the release latch.
Turn the hard-drive assembly module and align the tabs on the hard-drive assembly with the slots on the chassiis.
Align the screw hole on the hard-drive assembly module with the screw hole on the cover.
Replace the M2x3 screw to secure the hard-drive assembly module to the cover.