- Notes, cautions, and warnings
- Views of OptiPlex Tower Plus 7020
- Set up your OptiPlex Tower Plus 7020
- Specifications of OptiPlex Tower Plus 7020
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Ethernet
- Wireless module
- Audio
- Storage
- Redundant Array of Independent Disks (RAID)
- Media-card reader
- Power ratings
- GPU—Integrated
- GPU—Discrete
- Hardware security
- Environmental
- Regulatory compliance
- Operating and storage environment
- Working inside your computer
- Removing and installing side cover
- Removing and installing coin-cell battery
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Power button
- Wireless antenna kit
- Processor fan and heat-sink assembly
- Power-supply unit
- System fan
- Processor
- Voltage-regulator heat sink
- Optional I/O modules
- System board
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex Tower Plus 7020 Owner's Manual
Removing the front bezel
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the side cover.
About this task
The following images indicate the location of the front bezel and provide a visual representation of the removal procedure.
Steps
- Using a plastic scribe, gently pry the tabs sequentially from the top and release the tabs on the front bezel.
- Rotate the front bezel outward from the chassis and remove the front bezel.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\