OptiPlex Tower Plus 7020 Owner's Manual

Installing the optional USB Type-C module

About this task

The following images indicate the location of the optional USB Type-C module and provide a visual representation of the installation procedure.

1. Using a screwdriver, remove the optional-module cover from the chassis.
   NOTE:This step is applicable only when the optional USB Type-C module is being installed for the first time.

   NOTE:To remove the optional-module cover, insert a flat-head screwdriver in the hole of the cover, push the cover to release it, and then lift the cover off the chassis.
2. Insert the optional USB Type-C module in the slot on the chassis.
3. Connect the optional USB Type-C-module cables (VIDEO and TYPE-C) to the respective connectors on the system board.
4. Replace the two screws (M3x3) to secure the optional USB Type-C module to the chassis.