Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex Tower Plus 7020 Owner's Manual

PDF

Installing the network card

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the network card and provide a visual representation of the installation procedure.

Figure 1. Installing the network card
Image of installing the network card

Steps

  1. Lift the pull tab on the PCIe door outwards to open the PCIe door.
  2. Remove the PCIe blanking plate from the slot on the chassis.
    NOTE:Ensure to keep the PCIe blanking plate safe for future use.
  3. Align the notch on the network card with the tab on the PCIe card connector (SLOT1) on the system board.
  4. Gently press down on the network card till the tab on the PCIe connector locks in place.
  5. Close the PCIe door and press it gently until it clicks in place on the chassis, to secure the network card.

Next steps

  1. Install the side cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\