Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex Tower Plus 7020 Owner's Manual

PDF

Installing the media-card reader

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the media-card reader and provide a visual representation of the installation procedure.

Figure 1. Installing the media-card reader
Image of installing the media-card reader

Steps

  1. Connect the media-card reader to the connector (SD CARD) on the system board.
  2. Replace the screw (M2x3.5) to secure the media-card reader to the system board.
  3. Align and insert the tabs on the media-card reader door in the slots on the chassis.
  4. Close the media-card reader door.
  5. Replace the screw (M3x3) to secure the media-card door bracket to the chassis.

Next steps

  1. Install the front bezel.
  2. Install the side cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\