Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex 5400 Service Manual

PDF

Installing the camera assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the camera assembly and provides a visual representation of the installation procedure.

Image: Installing the camera

Steps

  1. Route the camera cable through the routing guides on the display-assembly base.
  2. Slide the camera assembly on the middle frame, and align the screw holes on the camera assembly with the screw holes on the middle frame.
  3. Replace the two screws (M3x5) to secure the camera assembly to the middle frame.
  4. Connect the camera cable to the system board.
  5. Align the screw holes on the camera door with the screw holes on the display-assembly base.
  6. Replace the two screws (M3x5) to secure the camera door to the display-assembly base.

Next steps

  1. Install the system-board shield.
  2. Install the back cover.
  3. Install the cable cover (optional).
  4. Install the stand.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\