If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the processor and provides a visual representation of the installation procedure.
Steps
Align the pin-1 corner of the processor with the pin 1 corner of the processor socket, and then place the processor in the processor socket.
NOTE:The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the processor socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more corners of the processor are higher than the others, the processor is not seated properly.
When the processor is fully seated in the socket, close the processor cover.
Press down and push the release lever under the tab to lock it.
Next steps
Install the heat-sink.
Install the front bezel.
Install the side cover.
Follow the procedure in after working inside your computer.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\