- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 5000 Tower
- Side cover
- Front bezel
- 2.5-inch hard-drive assembly
- 3.5-inch hard-drive assembly
- Solid-state drive
- WLAN card
- Coin-cell battery
- Memory module
- Expansion card
- Slim optical-drive
- Slim optical-drive bracket
- Speaker
- Fan duct
- Power-supply unit
- Processor fan and heat-sink assembly
- Processor
- Communication card
- Power button
- Intrusion switch
- SD card reader (optional)
- Optional modules
- Removing optional DisplayPort module
- Installing optional DisplayPort module
- Removing optional VGA module
- Installing optional VGA module
- Removing optional HDMI module
- Installing optional HDMI module
- Removing optional Serial module
- Installing optional Serial module
- Removing optional Type-C module
- Installing optional Type-C module
- Removing internal antenna
- Installing internal antenna
- System board
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex 5000 Tower Service Manual
Removing the SD card reader
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the side cover.
- Remove the front bezel.
- Remove the fan duct.
About this task
The following image indicates the location of the SD card reader and provides a visual representation of the removal procedure.
Steps
- Remove the screw that secures the SD card reader to the system chassis.
- Disconnect the SD card reader from its connector on the system board.
- Lift to remove the SD card reader.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\