Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex 5000 Tower Service Manual

PDF

Installing the system board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the connectors on your system board.

System board layout

  1. ATX CPU power connector
  2. ATX CPU power connector
  3. Memory module connectors
  4. Power button connector
  5. SD card reader connector
  6. System power connector
  7. SATA power cable connector
  8. Coin-cell battery
  9. SATA3 connector (white)
  10. SATA 1connector (black)
  11. SATA 2 connector (black)
  12. M.2 WLAN connector
  13. SATA0 connector (blue)
  14. PCIe x16 (Slot2)
  15. PCIe x4 (Slot4)
  16. PCIe x1 (Slot1/2)
  17. PCIe x1 (Slot1/2)
  18. M.2 PCIe SSD connector
  19. Type-C connector
  20. Processor socket
  21. Keyboard and Mouse serial connector
  22. Video connector
  23. Intrusion switch connector

The following images indicate the location of the system board and provide a visual representation of the installation procedure.

Place the system board into the chassis

Installing the system board

Replace the eight screws to secure the system board

Replace the single screw to secure the I/O bracket

Steps

  1. Slide the front I/O-ports on the system board into the front I/O-slots on the chassis and align the screw holes on the system board with the screw holes on the chassis.
  2. Replace the (M2x4) screw screw to secure the system board to the chassis.
  3. Replace the eight (#6-32) screws that secure the system board to the chassis.
  4. Route the cables through the routing guides on the chassis and connect the power and HDD cables to their respective connectors on the system board.
  5. Align the front I/O-bracket with the slots on the chassis.
  6. Replace the two (#6-32) screws that secure the front I/O-bracket to the chassis.

Next steps

  1. Install the processor.
  2. Install the processor fan and heat-sink assembly.
  3. Install the coin-cell battery.
  4. Remove the intrusion switch.
  5. Remove the speaker.
  6. Install the graphics card.
  7. Install the M.2 2230 SSD/M.2 2280 SSD.
  8. Install the WLAN.
  9. Install the memory module.
  10. Install the fan duct
  11. Install the front bezel.
  12. Install the side cover.
  13. Follow the procedure in after working inside your computer.
    NOTE:Your computer’s Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program after you replace the system board.
    NOTE:Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup program. You must make the appropriate changes again after you replace the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\