If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system board and provides a visual representation of the installation procedure.
Steps
Align and lower the system board into the system until the connectors at the back of the system board align with the slots on the chassis, and the screw holes on the system board align with the standoffs on the system.
Replace the two (M3x4) screws and three (6-32) screws to secure the system board to the chassis.
Align the slot on the hard drive caddy support with system board and place the hard drive caddy on the system board.
Replace the screw (6-32) to secure the hard drive caddy support to the system board.