OptiPlex 3000 Micro Service Manual

PDF

Screw list

NOTE:When removing screws from a component, it is recommended to note the screw type, and the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.

NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component.

NOTE:Screw color may vary with the configuration ordered.

Table 1. Screw listThe following table provides the different screws that are used in your OptiPlex 3000 Micro.
Component	Screw type	Quantity	Image
Side cover	#6-32 (Captive screws)	1
System board	M3x5 M3x4L	5 3
Heat sink	M3x25 (Captive screws)	3
WLAN card	M2x3.5	1
M.2 2230/2280 Solid-state drive	M2x3.5	2
Internal Antenna	M3x3MM	3