NOTE: : On WinRM version 2.0,
enable the compatibility mode for WinRM version 2.0 to use port 443.
WinRM version 2.0 uses port 5986 by default. To enable the compatibility
mode, type the following command:
winrm s winrm/config/Service @{EnableCompatibilityHttpsListener="true"}
Open a command prompt.
Type winrm g winrm/config.
Check the value of the MaxEnvelopeSizekb attribute.
If the value is less than 4608, type the following command:
winrm s winrm/config @{MaxEnvelopeSizekb="4608"}
Set the value of MaxTimeoutms to 3 minutes:
winrm s winrm/config @{MaxTimeoutms ="180000"}
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\