- Notes, cautions, and warnings
- Introduction
- Preinstallation Setup
- Prerequisite Checker
- Installation Requirements
- Configuring SNMP Agents
- Secure Port Server And Security Setup
- Remote Enablement Requirements
- Installing Managed System Software On Microsoft Windows Operating Systems
- Deployment Scenarios For Server Administrator
- Installer Location
- Installing Server Administrator
- System Recovery On Failed Installation
- Upgrading Managed System Software
- Uninstalling Managed System Software
- Deployment Scenarios For Server Administrator
- Installing Managed System Software On Microsoft Windows Server and Microsoft Hyper-V Server
- Using Microsoft Active Directory
- Active Directory Schema Extensions
- Extending The Active Directory Schema
- Frequently Asked Questions
Dell EMC OpenManage Installation Guide — Microsoft Windows Version 9.3.1
Configuring Active Directory To Access The Systems
Before you
can use Active Directory to access the systems, you must configure
both the Active Directory software and the systems.
- Extend the Active Directory schema.
- Extend the Active Directory Users and Computers Snap-in.
- Add system users and their privileges to Active Directory.
- For RAC systems, enable SSL on each of the domain controllers.
- Configure the system’s Active Directory properties using either the Web-based interface or the CLI.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\