Opening The
Active Directory Users And Computers Snap-In
To open the
Active Directory Users and Computers snap-in, perform the following
steps:
If you are on the domain controller, click Start > Admin Tools > Active Directory Users and Computers. If you are not on the domain controller, you must
have the appropriate Microsoft administrator pack installed on the
local system. To install this administrator pack, click Start > Run, type MMC, and press <Enter>.
Click File in the Console
1 window.
Click Add/Remove Snap-in.
Click Add.
Select the Active Directory Users and Computers snap-in and click Add.
Click Close and click OK.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\