The iDRAC Quick Sync Read feature enables
your mobile device to act as a proximity reader to read data from
your server when the device is in contact with the iDRAC Quick Sync
Bezel.
NOTE: For the latest bug
fixes, we recommend upgrading your iDRAC firmware. For more information
about upgrading the iDRAC firmware see, iDRAC User’s Guide.
NOTE: This feature
is applicable only for Dell’s 13th generation of PowerEdge servers
with the iDRAC Quick Sync Bezel.
NOTE: Reading iDRAC information
via Quick Sync is not password protected. Making configuration changes
via iDRAC Quick Sync requires iDRAC credentials with appropriate permission.
To add an
iDRAC using iDRAC Quick Sync Read:
Start OpenManage Mobile.
If applicable, type the OpenManage Mobile Password
and tap Login.
The OpenManage Mobile homescreen is displayed.
Tap the symbol.
The Add screen is displayed.
Select iDRAC Quick Sync Read.
Tap Launch iDRAC Quick Sync.
Figure 1. iDRAC Quick Sync Read
Turn on the iDRAC Quick Sync Bezel.
Place your mobile device in contact with the
activation switch of the iDRAC Quick Sync Bezel on your server and
hold your mobile for at least 3 seconds.
NOTE: The Near-Field Communication (NFC) chip in the mobile device should
be in contact with the iDRAC Quick Sync activation switch. Refer to
your mobile device’s documentation to find the location of the NFC
chip.
Your server will be added to the list of servers
managed by OpenManage Mobile.
NOTE: The iDRAC Quick Sync
Bezel remains activated for about 30 seconds. If you do not manage
to add the iDRAC within the 30 seconds, reactivate the iDRAC Quick
Sync Bezel and retry step 7.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\