You can use NTP to synchronize the OMIVV appliance clocks to that of an NTP server.
Steps
In the Administration Console, on the
APPLIANCE MANAGEMENT page, click
Edit in the
NTP Settings area.
Select
Enabled. Enter the hostname or IP address of a preferred and secondary NTP server and click
Apply.
After configuring NTP, start the terminal console and select the
Sychronize date and time over the network check box.
Results
NOTE It might take few minutes for the OMIVV clock to synchronize with the NTP server.
NOTE If the OMIVV admin portal is taking a long time to load information, ensure that NTP settings are correct and the NTP server is reachable by the OMIVV virtual machine.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\