- Notes, cautions, and warnings
- Introduction
- Install and configure OMIVV
- Prerequisite checklist
- Download OpenManage Integration for VMware vCenter
- Deploy OMIVV OVF using vSphere Client (HTML-5)
- Generate a Certificate Signing Request (CSR)
- Upload HTTPS certificate
- Restore default HTTPS certificate
- Configure deployment mode
- Register vCenter server using a non-administrative account
- Register new vCenter server
- Configure OMIVV appliance
- Configure OMIVV appliance with two Network Interface Controllers (NICs)
- Change OMIVV appliance password
- Configure Network Time Protocol (NTP) and set local time zone
- Change hostname of OMIVV appliance
- Reboot OMIVV appliance
- Reset OMIVV appliance to factory settings
- Reconfigure OMIVV after upgrading registered vCenter version
- Recover OMIVV after un-registration
- Upgrade OMIVV appliance and repository location
- Configure OMIVV appliance using initial configuration wizard
- Accessing documents from the Dell EMC support site
- Related Documentation
- Contacting Dell
OpenManage Integration for VMware vCenter Version 5.2 Installation Guide
Reconfigure OMIVV after upgrading registered vCenter version
About this task
- For non-administrator users:
- Assign extra privileges to non-administrator users, if necessary. See
Required privileges for non-administrator users.
For example, when you upgrade from vCenter 6.0 to vCenter 6.5, assign the extra privileges.
- Reboot the registered OMIVV appliance.
- If the registered vCenter is 7.0 or later, enable the vSphere LifeCycle Manager in the OMIVV administration console.
- Assign extra privileges to non-administrator users, if necessary. See
Required privileges for non-administrator users.
- For administrator users:
- Reboot the registered OMIVV appliance.
- If the registered vCenter is 7.0 or later, enable the vSphere LifeCycle Manager OMIVV administration console.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\