After you complete the basic installation of OMIVV and registration of the vCenters, the Initial Configuration Wizard is displayed automatically for the first time, when you launch OMIVV in vCenter.
If you want to launch the initial configuration wizard later, go to:
On the
Welcome page, read the instructions, and then click
GET STARTED.
On the
Select vCenter page, from the
vCenters drop-down menu, select a specific vCenter or
All Registered vCenters, and then click
NEXT.
NOTE If you have multiple vCenter servers that are part of the same PSC registered with the same OMIVV appliance, and if you choose to configure a single vCenter server, repeat step 2 until you configure each vCenter.
On the
Create Host Credential Profile page, click
CREATE HOST CREDENTIAL PROFILE.
After hosts are added to a host credential profile, the IP address of OMIVV is automatically set as SNMP trap destination for host's iDRAC. OMIVV enables the WBEM service and then disables after retrieving iDRAC IP for hosts running ESXi 6.5 and later.
OMIVV uses the WBEM service to properly synchronize the ESXi host and the iDRAC relationships. If configuring the SNMP trap destination fails for particular hosts, and/or enabling the WBEM service fails for particular hosts, those hosts are listed as non-complaint. To view and fix the non-compliance, see
the Management Compliance
section in User's Guide.
On the
Configure Additional Settings page, do the following:
Schedule inventory jobs. For more information about scheduling the inventory job, see
Schedule inventory job.
Schedule warranty retrieval job. For more information about scheduling the warranty retrieval job, see
Schedule warranty retrieval jobs.
If you want to modify the inventory job schedule, go to
Settings > vCenter Settings > Data Retrieval Schedule > Inventory Retrieval or
Jobs > Inventory > Hosts Inventory.
If you want to modify the warranty retrieval job schedule, go to
Settings > vCenter Settings > Data Retrieval Schedule > Warranty Retrieval or
Jobs > Warranty.
Configure events and alarms. For information about configuring events and alarms, see
Configure events and alarms.
To apply individual settings, click the
Apply button separately, and then click
NEXT.
It is highly recommended to enable all the additional settings. If any of the additional settings are not applied, a message is displayed indicating that the all the additional settings are mandatory.
On the
Next Steps page, read the instructions, and then click
FINISH.
It is recommended that you associate your OMIVV hosts with a configuration baseline because it enables you to closely monitor the configuration changes happening in hosts and associated clusters. Configuration baseline can be created for any cluster once the hosts are successfully managed by OMIVV. To create a configuration baseline, do the following:
Create Repository Profile for Firmware and Driver—This helps you to define baselined firmware and driver versions.
Create System Profile—This helps you to define baselined hardware configurations for hosts.
Create Cluster Profile—To create successful baseline, select clusters and associate firmware, drivers, and hardware configurations.
The hosts present in a PowerEdge MX chassis with an iDRAC IPv4 disabled has to be managed using a chassis credential profile.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\