- Notes, cautions, and warnings
- Introduction
- Install and configure OMIVV
- Prerequisite checklist
- Download OpenManage Integration for VMware vCenter
- Deploy OMIVV OVF using vSphere Client (HTML-5)
- Generate a Certificate Signing Request (CSR)
- Upload HTTPS certificate
- Restore default HTTPS certificate
- Configure deployment mode
- Register vCenter server using a non-administrative account
- Register new vCenter server
- Configure OMIVV appliance
- Configure OMIVV appliance with two Network Interface Controllers (NICs)
- Change OMIVV appliance password
- Configure Network Time Protocol (NTP) and set local time zone
- Change hostname of OMIVV appliance
- Reboot OMIVV appliance
- Reset OMIVV appliance to factory settings
- Reconfigure OMIVV after upgrading registered vCenter version
- Recover OMIVV after un-registration
- Upgrade OMIVV appliance and repository location
- Configure OMIVV appliance using initial configuration wizard
- Accessing documents from the Dell EMC support site
- Related Documentation
- Contacting Dell
OpenManage Integration for VMware vCenter Version 5.2 Installation Guide
Configure Network Time Protocol (NTP) and set local time zone
Steps
- Open the OMIVV web console.
-
In the
OpenManage Integration for VMware vCenter Virtual Appliance Setup utility, click
Date/Time Properties.
Ensure to enter the NTP details in Admin console. For more information, see Set up Network Time Protocol (NTP) servers.
-
On the
Date and Time tab, select
Synchronize date and time over the network.
The NTP Servers window is displayed.
- To add another NTP server IP or hostname (if required), click the Add button, and then press TAB.
- Click Time Zone, select the applicable time zone, and then click OK.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\