- Notes, cautions, and warnings
- About using this guide
- Introduction
- Prerequisites
- Install ObjectScale on an online, externally-connected cluster
- Prepare the OpenShift cluster
- Download the charts .tgz and signature verification files from Dell Support
- (Optional) Verify downloaded files and the online image signatures pulled from DockerHub
- Create and prepare the necessary namespaces in Red Hat OpenShift
- Deploy the Bare-Metal CSI Driver for ObjectScale
- Install ObjectScale onto the OpenShift cluster
- Complete the initial setup of ObjectScale
- Next steps with ObjectScale
- Install ObjectScale on an offline cluster
- Prerequisites to install ObjectScale on an offline OpenShift cluster
- Prepare the OpenShift cluster
- Download the charts, software images, and signature verification files from Dell Support
- Verify the downloaded files needed to install ObjectScale on an offline cluster
- Upload ObjectScale images to the private registry
- Create and prepare the necessary namespaces in Red Hat OpenShift
- Deploy CSI bare-metal driver and ObjectScale
- Complete the initial setup of ObjectScale
- Next steps with ObjectScale
- Getting started with ObjectScale
- Upgrades
- Uninstall ObjectScale
Dell ObjectScale Application 1.3.x Installation Guide for Red Hat OpenShift
Run S3 workloads using the ObjectScale resources
Now that you set up object storage using an object store and a bucket, you can now begin to run S3 workloads.
Follow these tasks to run S3 or S3 Select workloads using ObjectScale:
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\