- Notes, cautions, and warnings
- About using this guide
- Introduction
- Prerequisites
- Install ObjectScale on an online, externally-connected cluster
- Prepare the OpenShift cluster
- Download the charts .tgz and signature verification files from Dell Support
- (Optional) Verify downloaded files and the online image signatures pulled from DockerHub
- Create and prepare the necessary namespaces in Red Hat OpenShift
- Deploy the Bare-Metal CSI Driver for ObjectScale
- Install ObjectScale onto the OpenShift cluster
- Complete the initial setup of ObjectScale
- Next steps with ObjectScale
- Install ObjectScale on an offline cluster
- Prerequisites to install ObjectScale on an offline OpenShift cluster
- Prepare the OpenShift cluster
- Download the charts, software images, and signature verification files from Dell Support
- Verify the downloaded files needed to install ObjectScale on an offline cluster
- Upload ObjectScale images to the private registry
- Create and prepare the necessary namespaces in Red Hat OpenShift
- Deploy CSI bare-metal driver and ObjectScale
- Complete the initial setup of ObjectScale
- Next steps with ObjectScale
- Getting started with ObjectScale
- Upgrades
- Uninstall ObjectScale
Dell ObjectScale Application 1.3.x Installation Guide for Red Hat OpenShift
Prerequisites to install ObjectScale on an offline OpenShift cluster
Ensure that the following prerequisites are met before beginning:
- A Linux system with sufficient free space (at least 150 GB) and network connectivity to the local repository. The Linux system is used to download, extract, and push the ObjectScale software to the local repository.
- kubectl 1.25 and 1.26
- Dell recommends using a virtual machine with Docker, with:
NOTE:If you are using a private docker registry with no HTTPS: Enable insecure registries.
- Login credentials for the local docker registry
- All Certificates applied to push and pull docker images
- Running private docker registry (address:port)
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\