- Notes, cautions, and warnings
- About using this guide
- Introduction
- Prerequisites
- Install ObjectScale on an online, externally-connected cluster
- Prepare the OpenShift cluster
- Download the charts .tgz and signature verification files from Dell Support
- (Optional) Verify downloaded files and the online image signatures pulled from DockerHub
- Create and prepare the necessary namespaces in Red Hat OpenShift
- Deploy the Bare-Metal CSI Driver for ObjectScale
- Install ObjectScale onto the OpenShift cluster
- Complete the initial setup of ObjectScale
- Next steps with ObjectScale
- Install ObjectScale on an offline cluster
- Prerequisites to install ObjectScale on an offline OpenShift cluster
- Prepare the OpenShift cluster
- Download the charts, software images, and signature verification files from Dell Support
- Verify the downloaded files needed to install ObjectScale on an offline cluster
- Upload ObjectScale images to the private registry
- Create and prepare the necessary namespaces in Red Hat OpenShift
- Deploy CSI bare-metal driver and ObjectScale
- Complete the initial setup of ObjectScale
- Next steps with ObjectScale
- Getting started with ObjectScale
- Upgrades
- Uninstall ObjectScale
Dell ObjectScale Application 1.3.x Installation Guide for Red Hat OpenShift
About ObjectScale upgrades
You can perform ObjectScale software upgrades from the ObjectScale Portal user interface, under . See the "Maintain ObjectScale" chapter in the ObjectScale Administration Guide to understand and complete upgrades to newer versions of ObjectScale, its components, and object stores.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\