- Notes, cautions, and warnings
- About this guide
- S5200F-ON Series switch
- Site preparations
- S5200F-ON Series switch installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission statement
- European Union directive conformance statement
- India
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell support
Dell PowerSwitch S5200F-ON Series Installation Guide July 2023
Two U four-post rack assembly
Due to the chassis weight, the S5296F-ON switch does not support a two-post rack installation; you must install the S5296F-ON in a four-post rack.
NOTE:To install the S5212F-ON switch, see One-half U front-rack installation. To install the S5224F-ON, S5232F-ON, or S5248F-ON, switch see, One U ReadyRail installation.
To install in a four-post rack, follow the instructions in your rack frame kit. In a four-post rack, the maximum distance between the front and back vertical posts is 36 inches (91.44 cm); the minimum distance is 24 inches (60.96).
CAUTION:Use
two people, an equipment lift, or pallet jack when lifting or moving
the chassis. Install the chassis into the rack before inserting the
chassis components. Lift the chassis only from the bottom. Lifting
by the chassis shelves or power supply openings might damage the chassis.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\