- Notes, cautions, and warnings
- About this guide
- S5200F-ON Series switch
- Site preparations
- S5200F-ON Series switch installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission statement
- European Union directive conformance statement
- India
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell support
Dell PowerSwitch S5200F-ON Series Installation Guide July 2023
Power cable clip installation
Your switch ships with two wire power cable clips. The following describes how to install the power cable clips that secure the power cables in place.
There are two loop holes above each power outlet on the switch. Connect the power cable clip above the right-most power outlet first.
- Insert the right side of one of the power cable clips into the right hole above the right-most power outlet.
- Twist the power cable clip to insert the left side of the power cable clip into the left hole above of the same power outlet.You may need to twist the power cable clip slightly to get the power cable clip fully inserted into the holes above the power outlet.
- Repeat the installation procedure with the second power cable clip on the second power outlet.
- Insert the power cords into the power outlets.
- Push the power cable clips over the power cables to secure them into place.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\