- Notes, cautions, and warnings
- About this guide
- S5200F-ON Series switch
- Site preparations
- S5200F-ON Series switch installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission statement
- European Union directive conformance statement
- India
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell support
Dell PowerSwitch S5200F-ON Series Installation Guide July 2023
Components
The following power supply options are available for the S5200F-ON Series switch:
- AC or DC power supply with integrated fan
- AC or DC power supply with integrated reverse flow fan, except S5212F-ON
- S5212F-ON only: AC or DC open-frame power supply without integrated fans
For the S5224F-ON, S5232F-ON, and S5248F-ON switches, power supply 1 (PSU1) is on the left side of the switch; power supply 2 (PSU2) is on the right side of the switch. For the S5212F-ON and S5296F-ON switches, both power supply 1 (PSU1) and power supply 2 (PSU2) are on the right side of the switch.
The S5224F-ON, S5232F-ON, or S5248F-ON PSUs:
- PSUs
The S5296F-ON PSUs:
- PSUs
The S5212F-ON AC PSUs:
- AC PSUs
The S5212F-ON DC PSUs:
- DC PSUs
The PSUs have an integrated fan, which you cannot replace individually; if the fan integrated in a PSU fails, you must replace the entire PSU. You can replace the fan trays individually. For fan tray replacement procedures, see Fans.
WARNING:Prevent exposure and contact with hazardous voltages.
Do not attempt to operate this switch with the safety cover removed.
CAUTION:Remove the power cable from the PSU before removing the PSU. Also,
do not connect the power cable before you insert the PSU in the switch.
NOTE:To comply with
the GR-1089 Lightning Criteria for Equipment Interfacing with AC or
DC Power Ports, use an external surge protection device (SPD) at the
AC or DC input of the router.
PSU LEDs
- Solid green—Input is OK.
- Flashing yellow—There is a fault with the PSU.
- Flashing green blink at 1Hz—Switch is in a standby/CR state.
- Off—PSU is off.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\