- Notes, cautions, and warnings
- About this guide
- S5200F-ON Series switch
- Site preparations
- S5200F-ON Series switch installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission statement
- European Union directive conformance statement
- India
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell support
Dell PowerSwitch S5200F-ON Series Installation Guide July 2023
Optics installation
The S5200F-ON Series (S5232F-ON, S5248F-ON, S5296F-ON, S5224F-ON, and S5212F-ON) switches have SFP+, SFP28, QSFP-DD, and QSFP28 optical ports.
For a list of supported optics, see the specification sheets at www.dell.com/support or contact your Dell Sales representative.
CAUTION:ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when handling the S5200F-ON Series switch and components.
WARNING:When working with optical fibers, follow all warning labels and always wear eye protection. Never look directly into the end of a terminated or unterminated fiber or connector as it may cause eye damage.
-
Position the optic to enter the port correctly.
The optic has a key that prevents it from being inserted incorrectly.
-
Insert the optic into the port until it gently snaps into place.
NOTE:When you cable the ports, be sure not to interfere with the airflow from the small vent holes above and below the ports.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\