- Notes, cautions, and warnings
- About this guide
- S5200F-ON Series switch
- Site preparations
- S5200F-ON Series switch installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission statement
- European Union directive conformance statement
- India
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell support
Dell PowerSwitch S5200F-ON Series Installation Guide July 2023
Important information
WARNING:To be NEBS-compliant:
- Locate your switch in a restricted-access area were only trained personnel are allowed access.
- Install and connect your switch to the common bonding network (CBN).
- You can also install and connect your switch to the central office.
- Connect the battery returns of your switch as DC-I.
- Use a shielded and grounded cable at both ends of the management port.
- Ground your switch using a copper ground conductor.
- Clean and coat all bare grounding connection points on your switch with an antioxidant solution before making connections.
- Bring all unplated ground connection surfaces on your switch to a bright finish and treat them with an antioxidant solution before making connections.
- To ensure electrical continuity, remove any nonconductive surfaces from the ground connection points and threaded holes that are used to secure the ground lugs.
- Use the two-hole, Listed, compression-type lug with an AWG 14 gauge wire for switch grounding.
- Dell Technologies recommends changing the front air filter every three months, depending on the switch environment (if applicable).
NOTE:If you install and connect the switches to a commercial AC power source, you must connect the switch to an external surge protection device (SPD).
NOTE:The intrabuilding ports of the equipment or subassembly are suitable for connection to intrabuilding or unexposed wiring or cabling-only of the intrabuilding port(s) of the equipment or subassembly. The intrabuilding ports must not be metallically connected to interfaces that connect to the OSP or its wiring. These interfaces are designed for use as intrabuilding interfaces only (Type 4 or 4a ports as described in
GR-1089: Electromagnetic Compatibility and Electrical Safety) and require isolation from the exposed OSP cabling with the addition of primary protectors.
NOTE:The S5232F-ON switch can operate at -40 VDC to -60 VDC at a maximum current level of 15A.
NOTE:The S5232F-ON switch is Earthquake Z4-compliant when you attach the rails to the frame using threaded hardware.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\