This guide provides information for the open networking (ON) diagnostic (DIAG) operating system (OS).
This system uses the power-on self-test (POST) diagnostic tool that automatically runs during the system power-on at the BIOS level. This tool tests for catastrophic hardware failures that prevent booting the system. The error code is saved in CMOS for the next boot. There is no physical alarm indication.
When the diagnostic tools finish, your system displays pass or fail test results. If all the tests pass, the diagnostic tools close. If a test fails, each diagnostic tool offers a different result.
To view all the ONIE commands available, from the ONIE prompt, enter onie- and press the <tab> key twice.
ONIE:/ # onie- <TAB><TAB>
onie-boot-mode onie-fwpkg onie-syseeprom
onie-console onie-nos-install onie-sysinfo
onie-start onie-self-update onie-uninstaller
onie-stop onie-support