- Notes, cautions, and warnings
- About this guide
- S4100–ON Series switch
- Site preparations
- S4100–ON Series installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission statement
- European Union EMC directive conformance statement
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell EMC support
S4100–ON Series S4128F-ON, S4148F-ON, and S4148FE Installation Guide November 2017
Unpack the switch
- NOTE: Before unpacking the switch, inspect the container and immediately report any evidence of damage.
When unpacking the S4100–ON Series switch, make sure that the following items are included:
- One S4100–ON Series (S4128F-ON, S4148F-ON, or S4148FE-ON) switch
- One RJ-45 to DB-9 female cable
- Two sets of rail kits, no tools required
- Two PSUs
- Four fan units
- Two country- and region-specific AC power cords
- Dell S4100–ON Series Setup Guide
- Safety and Regulatory Information
- Warranty and Support Information
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\