- Notes, cautions, and warnings
- Preface
- Introduction
- Licensing the NetWorker Server
- Licensing process
- Served license
- Unserved license
- Obtain the license server and NetWorker server IP address
- How to obtain the NetWorker license
- Installing the Dell license server (served licenses only)
- Managing the Dell License Server (served licenses only)
- Applying NetWorker 19.11 license
- Upgrading NetWorker license
- NetWorker 8.2.4 upgrade (Traditional license) to NetWorker 19.11 with served update entitlement license file
- NetWorker 8.2.4 upgrade (Traditional license) to NetWorker 19.11 with unserved update entitlement license file
- NetWorker 9.x or NetWorker 18.x upgrade to NetWorker 19.11 with served license
- NetWorker 9.x or NetWorker 18.x upgrade to NetWorker 19.11 with unserved license
- Unserved XML license
- Migrating to NetWorker XML license
- Additional Information About NetWorker Licensing
- About the traditional enabler-based licensing model
- The evaluation process
- License process flow
- Permanently license the NetWorker software
- Install the NetWorker software for evaluation, if required
- Send the purchase order
- Review the License Authorization Code letter
- Obtain the host ID of the NetWorker server
- Activate the software license certificate
- Download the NetWorker license key
- Delete all the evaluation enabler codes, if required
- Upgrade or downgrade the base enabler, if required
- Apply the license key on the NetWorker server
- Product licenses
- Troubleshooting and Best Practices
Dell NetWorker 19.11 Licensing Guide
Additions to the NSR RAP resource
After you complete the License Server installation and setup, the NSR Resource Access Protocol (RAP) resource is populated with the License Server information. The following figure provides an example of the information.
The attributes that are identified in the graphic (for example, CLP License server and CLP License server port) are populated from the license file stored in the NetWorker server host's /nsr/lic/ directory and from queries of the License Server. These attributes are updated each time that you check out a license. Then Solution ID and CLP SWID are read from a license that is checked out from the License Server and not from the license file on the NetWorker server.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\