Determines whether to issue informational, warning, or error messages when
monitoring SRP usage and the target device SRP used capacity exceeds the specified percentage during a LINK operation.
The default setting is SRP_PERCENT(100,INFO), which means no messages are displayed.
The SRP_PERCENT parameter can be specified on the
GLOBAL command. It applies to the LINK operations only and is ignored for other commands.
NOTE:The SRP reports total, FBA, and CKD capacity utilization values. Depending on the device type, only the CKD or FBA utilization is checked against the specified SRP_PERCENT percentage.
The percentage of used SRP capacity that the SRP must be above for the messages to be displayed. Valid values are 0 through 100. The default value is 100.
This parameter has a corresponding site option,
&SRPPERCT.
INFO|WARN|ERROR|SKIP
The default value is INFO.
Sets the severity level of messages to be displayed: informational (return code 0), warning (return code 4), or error (return code 8).
Regardless of this setting, SRP summary information is always displayed unless the SKIP parameter is specified.
The INFO, WARN, and ERROR keywords have a corresponding site option,
&SRPMSGLVL.
The SKIP option skips SRP usage processing. If SKIP is specified, no SRP information is obtained or displayed.
NOTE:Specify the SKIP parameter to speed up job processing when SRP information is not required.
The SKIP keyword has a corresponding site option,
&SRPMSGLVL.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\